4″ submersible pump of KMP INDUSTRRIES are multistage centrifugal units which operate below water level and are driven by water filled AC single phase (or) three phase induction submersible motors. There pumps are will suited for borewell diameter of minimum 4″ (or) 100 mm. A dynamically balanced rotor rotates in a oversized twin bearings on each bearing housing. An installed diaphragm in the lower motor housing provides pressure / volume compensation of the motor during internal motor temperature changes .
| Power Range | 0.75 H.P – 7.5 H.P |
| Speed | 2900 RPM |
| Operating Voltage | Single phase ( 180 V to 230 V ) AC |
| Three phase ( 360 V to 415 V ) AC |
| Delivery Pipe Size | 25mm, 32 mm , 40 mm , 50 mm |
| Max. Outer Diameter | 98 mm |
| Head Range | 25 mtrs – 570 mtrs |
| Discharge | 6.0 LPS – 0.2 LPS |
| Maximum Start / Hour | 20 times |
| Method of starting | CSCR – 1 Phase |
| DOL – 3 Phase |
| Outer pipe | S.S. 202 |
| Shaft | S.S. 410 |
| Thrust bearing | Impregnated Carbon / S.S |
| Bearing Bush | LTB 4 |
| Impeller / Diffuser | Noryl |
| Diaphragm | Nitrile butyl Rubber (NBR) |
- There is a wide range of pumps to match any duty point.
- High pump efficiency.
- Due to less weight installation cost is very less
- Semi axial impellers make priming automatic
- Easy to dismantle and repair due to right construction.
- Domestic water supply
- Small irrigation
- Civil and industrial applications
- Fire fighting applications