4″ Stainless Steel Submersible pumpsets of KMP INDUSTRRIES are multistage centrifugal units which operate below water level and are driven by water filled AC single phase (or) three phase induction submersible motors. There pumps are will suited for borewell diameter of minimum 4″ (or) 100 mm . These pumps work on principle of a modular structure where with limited number of parts different tailor made request can be achieved.Impellers and diffusers are manufactured with high grade stainless steel which can be well suited for salty conditions and better performance.
| Power Range | 1.0 H.P – 7.5 H.P |
|---|---|
| Speed | 2900 RPM |
| Operating Voltage | Single phase ( 180 V to 230 V ) AC |
| Three phase ( 360 V to 415 V ) AC | |
| Delivery Pipe Size | 32 mm |
| Max. Outer Diameter | 98 mm |
| Head Range | 25 mtrs – 350 mtrs |
| Discharge | 3.5 LPS – 0.3 LPS |
| Maximum Start / Hour | 20 times |
| Method of starting | CSCR – 1 Phase |
| DOL – 3 Phase |
| Outer pipe | S.S. 202 |
|---|---|
| Shaft | S.S. 410 |
| Thrust bearing set | Impregnated Carbon / S.S |
| Bearing Bush | LTB 4 |
| Impeller / Diffuser | Stainless Steel |
| Diaphragm | Nitrile Butyl Rubber (NBR) |
4″ submersible pump of KMP INDUSTRRIES are multistage centrifugal units which operate below water level and are driven by water filled AC single phase (or) three phase induction submersible motors. There pumps are will suited for borewell diameter of minimum 4″ (or) 100 mm. A dynamically balanced rotor rotates in a oversized twin bearings on each bearing housing. An installed diaphragm in the lower motor housing provides pressure / volume compensation of the motor during internal motor temperature changes .
| Power Range | 0.75 H.P – 7.5 H.P |
|---|---|
| Speed | 2900 RPM |
| Head Range | 25 mtrs – 570 mtrs |
| Discharge | 6.0 LPS – 0.2 LPS |
| Operating Voltage | Single phase ( 180 V to 230 V ) AC |
| Three phase ( 360 V to 415 V ) AC | |
| Delivery Pipe Size | 25mm, 32 mm , 40 mm , 50 mm |
| Max. Outer Diameter | 98 mm |
| Method of starting | CSCR – 1 Phase |
| DOL – 3 Phase | |
| Maximum Start / Hour | 20 times |
| Outer pipe | S.S. 202 |
|---|---|
| Shaft | S.S. 410 |
| Impeller / Diffuser | Noryl |
| Thrust bearing set | Impregnated Carbon / S.S |
| Bearing Bush | LTB 4 |
| Diaphragm | Nitrile butyl Rubber (NBR) |